RAMP MODES (continued):
2] Toggle Switch Middle: The modulation speed alternates
between slowing down and speeding up on each subsequent
TAP footswitch hold.
On first hold, the speed will continually SLOW DOWN. Once
released, it will stay at the new SLOWER speed. On the next hold,
the speed will continually SPEED UP, and on release it will stay
at the new FASTER speed.
This pattern will continue on each hold.
3] Toggle Switch Right: The modulation speed will continually
SPEED UP as long as the TAP footswitch is held down. Once the
TAP footswitch is released, the speed will return to where it was
before ramping was initiated.
FAVORITES / PRESETS
This pedal has ONE onboard FAVORITE setting that can be
accessed by holding the BYPASS footswitch or through an
external switch depending on the expression configuration. The
center LED will turn on to indicate the FAVORITE or a preset is
active.
Additional presets can be saved and accessed by using an
external MIDI controller. See the corresponding MIDI manual
for more details.
TO SAVE YOUR ONBOARD FAVORITE, simply hold both the
TAP and BYPASS footswitches for a couple seconds and then
release. The center LED will blink to indicate the save.
TO ALTER YOUR FAVORITE SETTING, activate the FAVORITE,
alter the parameters that you wish to change, and then re-save
the settings as you did the first time. A similar procedure applies
to saving MIDI presets.
Some notes about the onboard FAVORITE / PRESETS:
1] ALL knob locations are saved per preset.
2] Toggle Switch location is saved per preset.
3] Ramping Speed and Mode are saved per preset.
Below are additional settings t
hat ARENʼT s
aved in each
individual preset but ARE saved in the global settings of the
pedal and are retained / reloaded during power up:
1] Previous ON / OFF bypass state.
2] TRS Expression Mode.
3] Expression pedal mapping (if applicable).
4] MIDI Channel.
5] Ramping speed and mode used for “live” mode.
DETERMINE CURRENT FIRMWARE VERSION
Since these pedals support customer firmware updates through
the built-in micro-USB port, it can be useful to know what
firmware the pedal is currently running to determine if an update
is necessary.
To determine your firmware version:
1] Power the pedal on while holding the BYPASS footswitch.
2] Hold the BYPASS footswitch for MORE THAN 5 SECONDS.
3] The center LED will then blink a certain number of times
corresponding to the current firmware version. It will repeat the
firmware blink every 5 seconds as long as the BYPASS footswitch
is held.
4] Release the BYPASS footswitch to resume normal operation.
NOTE: Holding the BYPASS footswitch for more than 5 seconds
at power up has no effect on the configuration of the pedal
(external favorite, expression mode etc.).
If a firmware update is needed, please see the
DOCUMENTATION page at SwindlerEffects.com for downloads
and instructions.
05.16.2019
VER 1.0
