SANDFILTERSYSTEM PRO CLASSIC basic (DK,SE,UK,FI,NO,PL)
25
Swim & Fun Scandinavia ApS – [email protected] – www.swim-fun.com
system manometer shows the pressure inside the tank. If the pressure rises with approx. 0.2 -0.3 bar above the first
gauges level (approx. 0.4 bar), when the filter and sand was completely new and pure, it is time for a backwash.
7.
Cleaning the bottom of the pool
Switch the pump off. Use a hose clamp to connect a pool hose to the round suction plate of the pool skimmer.
Alternatively place a pool hose into the bottom of the skimmer. This will demand a sucking hose with a special muff
connector. Make sure all air comes is out of the hose before cleaning. Fill the hose with water by holding it in front of
the inlet to the pool while the pump is running. The air will hereby come out. The hoses can be air free under water
using a weight load. That could be a weighted vacuum cleaner mounted on a telescopic pole.
Set the lever on FILTER. Switch the pump on and brush the bottom and the walls. Make sure no air enters as it could
defuse the pump or cause damage to it by making it work without water.
When cleaning is finished, stop the pump, turn the lever to BACKWASH, switch the pump on and wash for one
minute to eliminate dirt. Switch the pump off, set the lever on RINSE and switch the pump on for half a minute for a
light rinse. Cleaning operations are now finished.
8.
User instructions for the 7-way valve
The filter system has a 7-way handle on top of the tank, wherefrom you can manually manage the cleaning process.
Press the handle down and rotate it to the desired position. Following positions are available:
FILTER: The dirty water comes from the pool and gets pressed down through the filter tank and gets filtered and
pumped back into the pool.
BACKWASH: The water comes from the pool and gets pushed op through the filter tank and pumped away to a drain
.
CIRKULATION: The water runs from the pool and returns again without getting filtered.
RINSE: The water comes from the pool and the top valve is cleaned from sand grains. This should be done after a
backwash procedure.
DRAIN: The water comes from the pool and is pumped directly out of the pool without filtration. Water can be lead
to a drain.
CLOSED: All positions are closed. The water cannot circulate. This position is used when the filter is connected to the
pool, but not in use.
WINTERIZE: This position is used during winter. Be sure that the sand filter and pump is 100% emptied from water
and demounted the pool. Place the system frost free during winter. (This position also relieves the gasket and sealing
in the valve).
NEVER use the valve lever as a handle to carry or lift the filter. It is not made for that use. The handle will simply break off.
9.
Storing in winter
At the end of the summer season, disconnect the hoses, remove water from the filter by opening the drain valve (8).
Water MUST be emptied from the pump as well and it must be placed in a dry place, where it cannot be damaged by
the cold. The pump and filter tank cannot endure frost – it will make damages the materiel and the warranty is no
longer valid. Put the handle in WINTERIZE position. We recommend that the sand will be changed once a year.