MV-1908-11--2017 . © All rights reserved Swim & Fun Scandinavia ApS
37
UK
tage gradually during installation over a ten minute period.
5. DO NOT touch the wire terminals when power is connected.
6. Wait for 10 minutes after the power is cut off and all indication lights are off before opening.
7. DO NOT use wet hands for operation.
8. Installation and repair on the Clever-Pool should only be carried out by a qualified electrician
CAUTION
9. Installation must conform to all local safety standards.
10. Installation and Maintenance must be carried out by a qualified electrician.
11. Connect power only after control panel is closed, electric shock could otherwise occur.
12. Do not touch the terminals, electric shock will occur if this rule is broken.
13. Do not disconnect power wires if power is connected, serious personal damage will occur if
this rule is broken.
14. NEVER touch circuit board or components.
15. Do not attempt a voltage duration test, Clever-Pool’s semiconductor elements may be damaged.
16. Ensure adequate air ventilation in summer or high ambient temperature, this will avoid conden-
sate being formed and possible electrical faults.
17. Please install the Clever-Pool in a dry, well ventilated and cool place.
1.1. PRODUCT CHECKS BEFORE INSTALLATION
Each Clever-Pool is fully tested at the factory. After delivery you will need to check for any damage
caused by transportation, if so please DO NOT connect to a power supply.
1.2. ENVIRONMENT
The correct environment for the function and life of the Clever-Pool is stated below:
→Indoor use
→Ambient temperature: -10
°C
to +40
°C
→No direct sunshine
→No oil or salt
→No corrosive fluid
→No dust or metal particles
→Away from radioactive or flammable substances
→No electromagnetic interference
→No direct rain or wet environment
→An RCD device MUST be used with this product.
