Swiftech Inc., 1703 E. 28
th
St., Signal Hill, CA 90806 T. (562) 595-8009 F. (562) 595-8769
NO
PARTS
PS
1
BEZEL, FRONT
1
2
BEZEL, FRONT, SUB
1
3
BUTTON, POWER
1
4
BUTTON, RESET
1
5
LENS
1
6
COVER, 5.25 FDD
4
7
COVER, 3.5 FDD
2
8
SPRING
1
9
PLATE, CAGE, 5.25
2
10
SPEAKER
1
11
BULKHEAD ASSY
1
12
SHIELD, I/O
1
13
CAGE, 3.5 ASSY
1
14
CARDGUIDE
1
15
POWER SUPPLY
1
16
BRACKET, P/S
1
17
COVER, TOP
1
18
CHASSIS, BOTTOM
1
NO
PARTS
PS
19 PANEL, FRONT
1
20 PANEL, REAR
1
21 SIDE, PANEL
2
22 CAGE, 5.25
1
23 FILLER TOP 3.5
1
24 BRACKET, HDD
1
25 SLIDE BRACKET P/S
1
26 BASE, M/B
1
27 CROSS BAR
1
28 BRACKET, LED ASSY
1
29 FAN 120MM
1
30 SNAP RIVET
8
31 SHIELD
1
32 THUMB SCREW
2
33 SCREW
1
34 RIVET, ALUMINUM
49
35 RIVET-SUS
8
36 SCREW
20
37
MEMORY BOARD CROSS
BAR
1
Components installation
1. Open the side-panel #21 by loosening thumb screws #32
2. Remove the main cross bar #27, and the memory board cross bar #37 (discard #37 bar if not needed)
3. Loosen screw #33, and remove the front bezel #1
4. Remove the top cover #17
You now have full access inside the case to proceed with the installation of your power-supply, motherboard,
hard drive (s) and various components.
Liquid cooling circuit notes
•
The water-block is installed onto the back-panel for safe shipping. Unscrew the 4 springs assemblies,
and remove the four aluminum standoffs used to secure the block to the back-panel.
You will need
these standoffs later, together with the spring and screw assemblies to install the water-block onto your
motherboard
.
•
During installation of your motherboard inside the case, it is good practice to strap the block out of the
way, using a rubber band for example.
•
Your cooling circuit is already filled with liquid
(75% pure water, 25% antifreeze). All you need to do is to
install the water-block to your CPU (follow separate instructions for AMD
or INTEL
processors).
•
Power to the pump: a spare power cord is provided to supply A/C power to the pump.
It needs to be
connected to an A/C outlet.
