background image

 

Copyright Swiftech 2001 – All rights reserved – Last revision date: Oct. 2001 
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28

th

 Street, Signal Hill, CA 90806 – Tel. 562-595-8009 – Fax 562-595-8769 

E Mail: Swiftech @swiftnets.com – URL: 

http://www.swiftnets.com

 

Information subject to change without notice

 

Page 3

III. Final inspection 

 
Now that the heat sink is installed, startup your computer, go into the BIOS and observe the CPU temperature.  Under normal ambient 
temperature conditions, the processor temperature should never exceed 55

°

 C (130 

°

 F).  If it does, shut down the computer immediately, 

and review your entire installation.  Troubleshooting help is available on our web site at 

www.swiftnets.com

, or by calling customer support at 

562-595-8009. 
 

Uninstall note

: CPU removal from some socket motherboards 

 
Once in place, the standoffs may slightly interfere with CPU removal in some motherboards:    
  
Depending on the manufacturers, sockets use either a plastic locking arm, or a metal locking arm. 

Sockets using a plastic locking arm

 require 

that the arm be slightly pried open at the center in order to release it from its retaining tab.  This can easily be done by inserting a thin screwdriver 
in between the socket body and the arm’s mid-section, and by slightly twisting the screwdriver in either direction, 

while pulling on the arm

. This 

will slightly arch the mid-section of the arm, and release it from its locking tab.  
 

DISCLAIMER: Swiftech assumes no liability whatsoever, expressed or implied, for the use of these products.  
 
 

 

 

I. Preparing the motherboard

 

4. 

You must uninstall your MB

 prior to installing the MCX462-U heat sink. 

5. 

Install standoffs in MB

.  

 

Nylon, hex nut

on back side of

the MB

Standoff

 

Do not install the Intel

 stock 

retention mechanism  

(black plastic 

frame).  

Remove it if it is  already 

installed.  

 
Install standoff in each one of the four 
holes surrounding the socket. Keep the 
standoff centered over the MB holes, and 
secure with nylon hex nuts on backside of 
the MB.  If you are going to 
assemble/disassemble the heat sink 
frequently, we recommend finishing the 
installation by putting a drop of “Crazy 
Glue “ at the junction between standoff & 
MB, and between nylon hex nut & MB. 
This will lock the standoff onto the MB, 
and further prevent it from spinning lose 
during frequent assembly and 
disassembly operations.

 

 

6. 

Re-install the MB 

inside the case.  

 
II. Heat sink Installation  

Отзывы: