11
IV. Assembling the microscope
The components for the S7 series microscopes are shipped detached for protection.
Open the styrofoam packing with care and do not leave any components attached to the
packing being removed. Do not discard any of the packing materials until all of the
components have been identified. Refer to the appropriate diagram from Section III to
identify all the components.
When handling the components, especially the optical pieces, avoid touching any lens
surfaces with bare hands or fingers, as fingerprints and grease stains affect image
quality.
Always assemble the microscope on a flat, stable surface.
There is anti-theft design of S7 eyepiece with the eyepiece locking screw in the
microscope eye tubes. Please loose the cross recessed screw in the tubes and slide
eyepieces into it. Tighten the locking screw after your eyepiece installation.
Refer to the appropriate diagrams on the following pages for how to assemble the
pieces for your specific S7 model.
For all models, note that the column stand allows for extreme flexibility in positioning
once assembled. Loosen the locking screw of the head holder or vertical pole locker
(boom stand), adjust the height of the head holder and lock the locking screw again.
Make sure that the support collar is secured firmly below the head holder or boom stand
main body holder along the vertical post. This is important as this collar keeps the
microscope from sliding down the column.
Содержание S7 Series
