Technical Support: 877-588-8748, option 2
|
www.swensonshear.com
|
PRECAUTIONS
Notchers - Do not lift notcher from the front as dies are sharp.
1.
Make sure the safety pin is securely in place before lifting
2.
The handles need to be facing up
3.
Lift from handles
Slitter Blade - Keep fingers out of the way of the blade.
Although the cutting wheel and bottom blade are not sharp to the touch, they will cut if fingers are in the
slitting path.
SnapTable PRO
Hyper-Lite
Setup Precautions
SNAPTABLE PRO
HYPER-LITE
SETUP
When you receive your SnapTable PRO Hyper-Lite you will also receive a components box that has all the loose parts that you will need to
install onto your SnapTable PRO Hyper-Lite before you use your SnapTable PRO Hyper-Lite
.
You will find four white panel guide rollers complete with t-handle, half inch by three shoulder
bolt and sleeve that goes inside the white roller.
To install, you slide the carriage bolt through the slot in the corner of the notching station
from underneath, slide the panel roller on top with insert in place and tighten with the
t-bolt and you will do this on all four corners of the notching station.
To attach handles, remove the preexisting bolts and attach. Use the center hole position
for initial use, handle position can be changed to suit operator’s preference.
Attach Slitter Handle to outside frame of slitter carriage using the two bolts included
in components box.
You will need to remove the cotter pin that's holding the notchers into that locked position. Once the notcher has been
released, you loosen the
9
/
16
bolt and lock nuts and you will see that the notcher has multiple locations depending on the
height of the user to adjust for optimal operation. Use a
9
/
16
wrench to tighten the bolts and your setup is complete.
