4 ©2021 SwellPro
Precaution
⚫
The GC1-S is a piece of precision electronics with corrosion-resistant materials
which allow for use in harsh marine environments. As with any marine equipment,
trouble-free and lasting operations depend on proper attention and maintenance of
the equipment.
⚫
When taking off or landing, slowly proceed to avoid damage to the gimbal camera
which can cause by the huge impact when contacting the surface at high speeds.
Drop or crash directly into the water from above will result in significant damage to
the drone and the gimbal camera.
⚫
After using in seawater, soak and rinse thoroughly with clean fresh water before the
seawater dries out.
⚫
If seawater or other sediments form on the gimbal camera, soak thoroughly with
fresh water and clean all sediments on the camera and motor before use. For more
information, check the
drone’s
“
Maintenance manual
”
.
Installation
Install the Gimbal
1. Unscrew and take off the gimbal port cover plate
using a hex screwdriver. (equipped with SplashDrone
4)
2.
Plug the gimbal connector into the drone’s gimbal
port and screw it in place with a screwdriver.
Make sure the rubber ring is attached to the gimbal
connector before you screw the connector.
Make sure the connector plate is clean and free of
any sand or other particles.
