Swegon GLOBAL LP FW, Инструкция по эксплуатации и обслуживанию

Страница: 13 / 60

13
Operation and maintenance instructions – v2.8.8 & 2.7.3
TAC5 DT: GLOBAL RX (TOP) & LP
(FW)
CT : output to CT actuator(s) (option - prewired) IN1 = Master selection
KWout = output for KWout capacity control (option - prewired) IN2 = dPa (pressostat digital input)
AL1 = ALARM OUTPUT (230V/5A) IN3 = Fire alarm input
B- / A+ / GND / +12V = connection to HMI IN4 = Bypass open / Stop heat recovery
K1 : Airflow control = m³/h K1 IN5 = Real time clock auto/manu
Demand/Pressure control = START/STOP IN6 = ON/OFF post heating (IBA/KWout)
Torque control = %torque K1 IN7 = ON/OFF SUPPLY if fire alarm
K2 : Airflow control = m³/h K2 IN8 = ON/OFF EXHAUST if fire alarm
Demand/Pressure control = 0-10V INPUT IN9 = BOOST Airflow
Torque control = %torque K2 IN12 = input pulse from heat exchanger magnet (prewired)
K3 : Airflow control = m³/h K3 OUT1 = 0-10V OUTPUT (airflow / pressure)
Demand/Pressure control = % ON K3 or 0-10 V INPUT OUT2 = 0-10V OUTPUT (airflow / pressure)
Torque control = %torque K3 OUT4 = 0-10V OUTPUT internal post heating (IBA)
T1 = from outdoors T° sensor (prewired) OUT5 = 24VDC / 1A
T2 = from indoors T° sensor (prewired) O.R.1 (output relay 1 - SAT3) = PRESSURE ALARM
T4 = IBA anti freeze protection T° sensor (option - prewired) O.R.2 (output relay 2 - SAT3) = FAN ON
T5 = supply T° sensor for IBA/KWout coil (option - prewired) O.R.3 (output relay 3 - SAT3) = HEATING DEMAND OUTPUT
PR1 = ΔPa from supply inlet fan (only on RX - option) O.R.4 (output relay 4 - SAT3) = BYPASS STATUS
PR3 = ΔPa from exhaust inlet fan (only on RX - option) R-GND : output for heat exchanger wheel speed command (prewired)
MAIN CONTROL BOARD TAC5 DT - CID026001