English version
Port settings
The Sweex 2 Port Serial ATA RAID PCI Card contains 4 visual Serial ATA connectors. Two of these can be used at the same time. You can opt to
connect Serial ATA devices externally, internally or a combination thereof.
You can determine the active ports by means of so-called Jumper settings (small black blocks on the card). The following is detailed at the jumper
blocks on the card:
Active connector
J1
J2
J3
J4
J5
J6
J7
J8
Con–1 and Con–2
2-3
2-3
2-3
2-3
2-3
2-3
2-3
2-3
Con–3 and Con–4
1-2
1-2
1-2
1-2
1-2
1-2
1-2
1-2
Con–1 and Con–4
2-3
2-3
2-3
2-3
1-2
1-2
1-2
1-2
Con–2 and Con–3
1-2
1-2
1-2
1-2
2-3
2-3
2-3
2-3
“1-2” means that the black jumper block must connect pins 1 and 2; 2 is not detailed on the 2 port Serial ATA RAID PCI card, this is the pin in the
middle. Thus in order to realise 1-2, the jumper block must be positioned on pin 1 (left on the pins and automatically also pin 2).
“2-3” means that the black jumper block must connect pins 2 and 3; 2 is not detailed on the 2 port Serial ATA RAID PCI card, this is the pin in the
middle. Thus in order to realise 2-3, the jumper block must be positioned on pin 3 (right on the pins and automatically also pin 2).
Warranty
All products under the Sweex brand are warranted for a period of three years. We do not grant support or warranties for any software and/or
(rechargeable) batteries included. Warranty claims are only settled via the dealer where the product concerned was purchased.
The rightful owner has and retains title to all brand names and related rights mentioned in this manual.
