English version
W W W . S W E E X . C O M
6
User setup
Mouse
Aim the front point of the mouse towards the receiver. Press the button on the rear side of the mouse and release, then press the connector
button on the receiver and release within 15 seconds. Move the mouse and if the cursor is moving then the setup of the mouse is completed. If
the cursor is not moving, please repeat the setup procedure.
Keyboard
Press the button on the rear side of the keyboard and release, then press the connector button on the receiver and release within 15 seconds.
Press the "Num Lock " key, if the Num indicator led of the receiver is changing status then the setup of the keyboard is completed. If not,
please repeat the setup procedure.
Mouse button function setup
Enter setup from the control desk or directly right-click into the mouse pattern shown in the right bottom corner of the screen and select active
mouse properties. The functions are as followed:
Button: Setup
for
using right or left hand, setup of the speed of clicking the mouse buttons twice, setup of scroll speed.
Pointers:
Choose your type of pointer.
Pointers options:
Setup of the moving speed and the length of the dragging tail.
Wheel:
Setup for hot key functions and zoom.
Hardware:
Type of mouse.
Press "OK" (Okay) after the setup is completed to store the new setup.
Troubleshooting
If the keyboard doesn't function well, please follow the steps below:
1. Check if the connector in the PS/2 port is connected properly.
2. Check if the positive (+) and negative (-) pole of the battery is placed correctly. If the power is low, the mouse will become slow.
3. Reset: Follow the setup of "User setup".
Warning!
Do not put the transmitter and receiver on a metal cabinet or metal desk. It is better not to have a metal or interference source around. This will
affect the RF communication and reduces the communication distance.
