8 Swedstyle Memory T
Swedstyle Memory T 9
5.3 DRILLING TEMPLATES
5.3.1 TOU CHFX
Fig. 8:
Drilling Template, TOUCHfx
38 mm
70 mm
SIDE EDGE
FRONT EDGE
4.1 Required components
Hand controller
Screwdriver
2 Mounting Screws
4.2 Process
1. Position the Handset under the table top and mark the position of the drilling holes.
If necessary, use the Drilling Template to help you.
2. Insert the Strain Relief into the designated slot on the Handset.
NOTICE
Inserting the Strain Relief incorrectly may cause damage to the Cable and Handset.
Ensure that the Cable does not protrude over the housing
3. Use the screwdriver and 2 Mounting Screws to attach the Handset to the Table Top at the
marked drilling points.
NOTICE
The required tightening torque depends on the material of the Table Top.
Do not exceed 2 Nm.
4.3 COMPLETING ASSEMBLY
After the ”Memory T” is attached to the Table Top, you must connect the Cable to
the Control Box.
DRILLING TEMPLATE
6.2 ASSEMBLY: TOUCH fx
6.2.1 REQUIRED COMPONENTS
1
TOUCHfx
2
2 Mounting Screws (supplied by Reseller)
Tool
Screwdriver
INFO
Thread diameter: max. 5 mm | Head diameter: 8.5 mm - 10.6 mm
If possible, do not use countersunk-head screws.
6.2.2 PROC ESS
1. Position the Handset under the table top and mark the position of the drilling holes. If necessary,
use the Drilling Template in chapter 5.3.1 to help you.
2. Insert the Stra in Reli ef into the designated slot on the Handset (Fig. 6).
NOTICE
Inserting the Strain Relief incorrectly may cause damage to the Cable and Handset.
Ensure that the Cable does not protrude over the housing
Fig. 10: Inserting the TOUCHfx Strain Relief
3. Use the screwdriver and 2 Mounting Screws to attach the Handset to the Table Top at the
marked drilling points.
NOTICE
The required tightening torque depends on the material of the Table Top. Do not exceed
2 Nm.
6.2.3 COMPLETING ASSEMBLY
After the TOUCHfx is attached to the Table Top, you must connect the Cable to the Control Box. Refer to the
manual for your chosen Control Box for instructions.
