INSTRUCTION BOOKLET
INSTRUCTION BOOKLET
INSTRUCTION BOOKLET
INSTRUCTION BOOKLET
5
USE OF FLOOR CLEANING ATTACHMENTS
These attachments can be used on linoleum, tiles, timber, concrete or carpeted floors. Different surfaces may or may not
require these attachments. For example, carpeted surfaces may require the brush attachment and smooth surfaces may
require the flat attachment.
1. To switch between the two head attachments, use your thumbs to simutaneously press inwards and downwards on
the tabs situated on the vacuum head. This will release the fitting.
2. Replace with the desired fitting by clicking it into place.
TO UTILIZE THE BLOWER FUNCTION
You may wish to utilize the product as a blower. Prior to utilizing the blower function, you must ensure the drum is
EMPTY and CLEAN.
1. Turn the product off at the power point.
2. Remove the valve cap by turning it anti-clockwise.
2. Remove the flexible hose from the front portal of the vacuum cleaner by twisting it anti-clockwise
3. Insert the hose into the portal located at the top of the product by twisting it clockwise
4. Turn the product on at the power point and via the switch located on the top of the product.
USING THE VACUUM AS A WET VAC
It is important to only use this vaccum cleaner to remove SMALL amounts of liqiud such as shampoo or spilt water. THIS
PRODUCT IS NOT TO BE USED AS A PUMP, CLEANING OR TRANSPORTING LARGE AMOUNTS OF LIQUID.
1. Remove the grey fine dust filter bag from the inside of the drum by detaching it from the air intake valve.
2. Do not allow the vacuum to fill up with fluid. It should be emptied when it reaches approximately 25% of capacity,
using the drain plug at the bottom of the unit.
3. Allow the drum to dry thoroughly before next use.
