Swarts Tools SW1075, Инструкция и информация о гарантии

Страница: 10 / 16

InstructIon booklet InstructIon booklet
10
InstructIon booklet InstructIon booklet
REPLACING / MOUNTING THE SAW BLADE
! WARNING
Before any work on the machine itself, pull the mains plug.
When mounting the saw blade, wear protective gloves. Danger of injury when touching the saw
blade.
Only use saw blades that correspond with the characteristic data given in the operating
instructions.
Selecting a Saw Blade
An overview of recommended saw blades can be found at the end of this manual.
REMOVAL OF THE SAW BLADE ( Fig1, Fig2, Fig3, Fig4).
For removing the blades, it is best to place the machine with the blade B printing side facing the
user.
Loosening
Fig1 Fig2 Fig3
Fig4 Fig5 Fig6
Tightening
Fig7
16
replacIng / mountIng the saw blade
WARNING Before commencing any work on the machine itself, disconnect the mains plug.
When mounting the saw blade, wear protective gloves, due to risk of injury.
Only use saw blades that correspond with the characteristic data given in the operating instructions.
REMOVAL OF THE SAW BLADE ( Fig1, Fig2, Fig3, Fig4).
When removing the blades, it is best to place the machine with blade B printing side facing the user.
changIng the saw blade
Unplug the power and allow the saw blade to cool down.
1. Press the spindle lock button, lock the driving shaft with the help of a spindle lock as in Fig 1.
2. Unscrew Blade bolt with the help of an Allen key in Clockwise Direction as in Fig 2.
3. Unscrew the Blade bolt with an Allen key turning in Clockwise Direction.
4. Open the lower guard as Fig 3.
5. To remove the 2 in 1 Twin Blade Pack from the spindle as Fig 4.
6. Open the lower guard as in Fig 5.
7. Place the 2 in 1 Twin Blade Pack onto the spindle and rotate around the blades to make sure the three driving
bosses on the blades to match the three notches on the output spindle; while the blades pack well seated, rotate
the two blades together could feel the gear collision as Fig 5, Fig 6.
8. Press spindle lock button and with the help of Allen key tighten the Blade bolt in counterclockwise direction as
Fig 7.
9. Release Spindle lock button and turn the Allen key to drive the blade rotating a couple turns, if the blades can
rotate smoothly; Remove the Allen key, the machine is ready for you to use.