swaploader SL-214, Руководство по эксплуатации и частям

Страница: 26 / 106

Section II: Installation
2.0.INS.SL-214
Screw insert in socket until insert touches the socket. Clean the inside of the hose
assembly by either blowing clean compressed air through it or by flushing it. Install the
completed hose assembly to the inlet port of the control valve assembly and the outlet port
of the hydraulic pump.
5. Tie up the pressure and suction hoses as necessary. Again, be sure the hoses are routed
to avoid exhaust components and to stay clear of the drive shaft.
HYDRAULIC TANK INSTALLATION
1. Select a location to mount the hydraulic tank. Reference Fig. G or Pg. 5-11 for the
suggested location of the hydraulic tank to the rear of the control valve assembly on the left-
hand side of the truck. The hydraulic hoses have been sized for the tank to be mounted in
this general area. The tank can be located on the right-hand side or behind the cab, if
necessary, which means longer hoses may be required.
2. Drill four (4) holes for 1/2” diameter bolts (provided) in the mount angle of the hydraulic tank
(two per angle) and the frame rails of the truck chassis. Mount the hydraulic tank and install
the hydraulic filter. Install the hydraulic return hose and the hose barb fitting between the
filter and the control valve assembly as shown on
Pg. 5-9 . The hose length can be
shortened if necessary. Secure the hose to the barb fittings with the hose clamps provided.
Figure G
2-14