GB
13
damaged or made unsafe by any operation,
lubrication, maintenance, or repair procedures
that you choose. Should any trouble or
unusual behavior be detected, do not start
splitting wood until these have been fixed.
1. Start the engine by pressing the green
switching button (33) then the cutter(14) will
go up to the top point together with Splitter
column(4) automatically.
2. Keep the feeder cable as short as possible
and select as big cross section as
possible.
3. when the temperature is low, let the
splitter run idle for app. 15 minutes so that
oil warms up to corresponding
temperature.
4. Put the split material(34) on the table(11)
and hold it using log catching claw(16)on
handle guard.
5. Splitting starts by pressing both operation
handle levers (6) down (as soon as the
splitting knife enters wood tip the lever
slightly out while pressing it down, this will
prevent holding sheets (arms) from
bending.
6. After finished splitting, release both
handles(6), the splitter cutter(14) will
automatically rise up.
7. Whenever the splitter cutter(14) rise up or
down, release anyone of handle(6), the
splitter cutter(14) will suspend on its
position.
NOTE: It is strictly prohibited to operate the
wood splitter in two persons with one holding
wood and the other one pressing on the
clamping plates, blocking one lever (clamping
plate) is prohibited too.
Assemly of the ”
＋
” blade
Sli
de the ”
＋
” cutter into the “
－
” cutter along
the direction of arrow, then tighten the screw(a)
on ”
＋
” cutter.
