SwanStone Swan DWP-369601, Руководство пользователя

Страница: 15 / 20

1. Measure and cut the corner moldings to length.
2. Dry fit the corner molding.
WARNING
Fumes Hazard
The fumes from the silicone and solvents used
by the installer can be harmful if used in an
unventilated room. Always work in a well-ventilated area.
To keep the area well-ventilated, open windows and use
exhaust fans. If adequate ventilation is not achievable or
practical, use respiratory protective equipment.
3. Clean the surface of the panels and the back of the
molding with denatured alcohol or another non-oil based
solvent.
IMPORTANT NOTICE
Do not use oil-based cleaners, such as mineral spirits, to
clean the panels. The oil in the cleaner will prevent the panel
from adhering properly to the wall.
4. Apply a 1/8 to 1/4” bead of silicone to the back of the
corner molding in an S pattern, as shown.
5. Press the corner moldings into place. Remove any excess
silicone.
6. Place at least three pieces of masking tape on each
corner molding to hold it in place until the silicone adheres
to the wall panel.
Final Caulking
Apply a bead of the color-matched 100% silicone sealant.
IMPORTANT NOTICE
Follow the manufacturer’s instructions on the tube for proper
application. Allow at least 24 hours for silicone to set before
using the shower enclosure.
800-325-7008 15 Swan
Installation Procedure