Swann ULAD-1913, Руководство пользователя

Страница: 8 / 16

To avoid damaging the sink or vanity top, do not
overtighten the screws and do not use a screw that is
too long. Use caution if using a variable speed drill to
install the screws. Install the screws just until they are
tight.
12. Position the sink on the adhesive and wiggle it
slightly to seat it on the countertop. Insert the two
screws in the pre-drilled holes and carefully tighten.
13. Clamp the sink in place using six to eight large
deep-throat clamps applied to the rim of the sink and
countertop, as shown.
14. Once the sink is securely clamped in place, carefully
remove one of the two screws from the rim of the
sink, then retighten that screw. Repeat for the
second rim screw. This will allow the clamps to
apply full pressure to the sink rim, without having the
sink slide out of position.
15. Record the time the sink was attached to the
countertop and allow the adhesive to cure for at
least one hour.
Note
: Be very careful not to disturb the acrylic adhesive
joints during the one hour cure time.
IMPORTANT NOTICE
The Swan Corporation 8 800-325-7008
Installation