4
Installing the LCD Screen and Intercom Camera
1)
The LCD screen and the intercom camera can
be mounted to almost any vertical surface. The
ideal mounting height is approximately 4.7 to
5.2ft/145 to 160cm from the ground. Use a 0.39in-
ch/10mm drill bit and drill a hole in the wall at
the location where you will be mounting the LCD
screen and the intercom camera.
2)
Use the supplied cable to connect the LCD
monitor to the intercom camera. On one end are
U-shaped connections. This connects to the wir-
ing terminal at the rear of the LCD screen (termi-
nals 1 to 4).
3)
Feed the other end of the cable through the
hole until it reaches the other side where the in-
tercom camera will be installed. Leave some of
the cable free so the U-shaped connections can
connect to the LCD screen.
4)
Place the LCD screen mounting bracket over
the hole (flat side with the square shaped hock
pointing up) and use the provided screws (2 x
1.18inch/3cm) to secure it to the wall. If you are
mounting to a masonry wall such as brick or
stone, use the provided plug to keep the screw
firmly in place.
5)
Connect the U-shaped connections to termi-
nals 1 to 4 by sliding the connection under each
screw and washer terminal. The colour on each
cable is for guidance only. It doesn’t matter which
colour is connected to each terminal. You just
need to make sure the same coloured wire is
connected to the same terminal on the intercom
camera, for example – blue wire connected to ter-
minal 1 on the LCD screen also connects to termi-
nal 1 on the intercom camera. Use a Phillips head
screwdriver to tighten each terminal (be careful
not to over tighten).