6
Installation Notes
4. Ensure the supply voltage of socket is same as rating label.
5. The plug must be properly inserted to the wall socket.
6.
The mains supply socket must be earthed - preferably with a switch. If it is not
earthed, do NOT install this appliance there. Do not use an extension cord
7. The product is equipped with adjustable feet. Once the product is in place, adjust
these to ensure the cooler is level and doesn’t rock.
DO NOT SITE THE PRODUCT WHERE THE AMBIENT TEMPERATURE IS LIKELY TO
DROP BELOW 5 DEGREES CENTIGRADE - EG: GARAGE OR SHED
1. It is important that upon receipt you stand your appliance upright for at least 1 hour before
switching on to allow the system to settle. Remove all packaging & any transit tapes
2. Clean the inside of the cabinet with a soft, dry cloth prior to switching on
3. When using the product for the first time, set the thermostat inside to MAX without any
bottles inside. When the appliance starts, you will hear the quiet hum of the compressor. You
may also hear the circulation of liquids and gases in the refrigeration system. This is normal
on first start up, Generally it will take up to 1 hour for the appliance to reach temperature.
Once temperature has been reached then put the drinks inside.
4. The temperature of the cooler can be adjusted by rotating the disc of the thermostat. The
higher the value on the setting of the thermostat, the maximum value of refrigeration (coldest
being 5). Typically a medium setting of 3 is best for most circumstances. Temperature range
in the cooler is typically 5 - 12 C depending on thermostat setting.
5. Do not put too much foodstuff in the cooler. Avoid opening the door too frequently as this
will waste energy.
First Time Use
SR12020_IM.indd 6
17/02/2014 08:59
