When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the Power switch button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dishwasher by pressing the Power button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
Change the Program...
Change the Program...
Forgot to Add a Dish?
Forgot to Add a Dish?
If you open the door during a wash cycle , the machine will pause. The program light will
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will keep on working after 10 seconds.
NOTE:
NOTE:
At the End of the Wash Cycle
At the End of the Wash Cycle
A forgotten dish can be added any time before the detergent cup opens.
Add forgotten dishes.
After the spray arms stop working,you can open the door
completely.
2
3
Open the door a little to stop the washing.
1
4
Close the door, the dishwasher will run
after 10 seconds.
When you open the door of dishwasher during washing, the running indicator will
stop blinking and the dishwasher will mooing every minute unless you close the
door to restart.
NOTE:
NOTE:
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
NOTE:
NOTE:
When following this procedure from step1 to step 3, the filter system will be removed;
when following it from Step 3 to Step 1, the filter system will be installed.
WARNING!
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
12
12
If your model has broken remember function, the machine will go on to finish the selected
program
after the power cut
.
1. A running cycle can only be modified if it has been running for a short time. If the detergent has
already been released and the water has already been drained out, the detergent dispenser must
be refilled.
2. Open the door carefully. When sprayers stop running, pless press the program button more than
3 seconds to cancel the running programme.
3. Select a new programme, then close the door to restart the dishwasher.
Содержание SDW7040
Страница 1: ......