Swann MF-1F, Руководство по установке

Страница: 8 / 12

3. If replacing an existing laundry tub, loosen and remove the
hot and cold water lines and waste pipe connections. Use
a container to catch any water remaining in the P-trap.
Note: If the P-trap and water lines are in poor condition,
replace them with new parts. Also replace any rusted
or corroded fittings with new parts. The faucet can be
reused and reinstalled.
4. Install the faucet assembly according to the
manufacturer’s instructions (homeowner supplied).
Note: Preinstallation of the faucet, supply lines, and P-trap are
easier when the laundry tub is not against and/or
attached to the wall.
5. Attach the two flexible water lines onto the faucet
(homeowner supplied). Do not over-tighten the connections.
6. Assemble the PVC trap components (homeowner supplied)
and attach them to the drain hole(s) in the laundry tub.
4. Final Installation
1. For models with legs, place the laundry tub where it will be
installed. For wall mount models, hang the sink onto the
wall mounting plate (see Step 2).
2. On wall mount models only, lift and place the sink over the
wall mounting plate. Make sure the laundry tub is seated
securely into the lip of the wall mounting plate.
3. Attach the PVC tailpiece (homeowner supplied) to the
drain pipe. Cut the tailpiece to the proper length using a
hacksaw, if necessary. Use sandpaper or a file to remove
any burrs or sharp edges.
LT-010
LT-030
LT-009
LT-008b
LT-008
LT-007
LT-006
The Swan Corporation – Swanstone 8 800-325-7008
Installation Procedure