3
CHIME SELECTION & PAIRING
ADJUSTING THE VOLUME
RESETTING THE CHIME SPEAKER
MOUNTING THE DOORBELL
CHIME SPEAKER MODES
You can assign a different chime to be played for the Doorbell. Follow the steps below:
1. Press the button repeatedly on the Chime Speaker to cycle through the available
sounds. Stop when you hear something you like.
2. Press and hold the
CODE
button on the Chime Speaker for 3 seconds. The Chime Speaker
goes into pairing mode, indicated by the LED glowing solid red.
3. Within 10 seconds, press the Doorbell button. The Chime Speaker responds with the
selected sound as confirmation. If pairing is not completed within 10 seconds, the Chime
Speaker double-beeps. In this case, you will need to start over from step 2.
Tip: Additional Chime Speaker and Doorbell units can be set up using the same method as above.
A Chime Speaker can support a maximum of 5 Doorbells at any one time. Additional Doorbells are
available for purchase separately.
The volume of the Chime Speaker is adjustable, if necessary. Simply press the
VOL
button
until the desired volume level is obtained.
To remove all pairing information from the Chime Speaker and start again, press and hold the
button on the Chime Speaker for 5 seconds until the LED glows solid red.
The Doorbell can be mounted by sticking it to a wall using the
included double-sided adhesive tape. The operating distance
between the Chime Speaker and Doorbell is up to 50m/165ft but
the range may vary depending on local conditions.
Note: The Doorbell is not suitable for mounting on metal surfaces
and UPVC doorframes as these materials will interfere with the
Doorbell's ability to communicate with the Chime Speaker.
Press the
MODE
button to set the Chime Speaker to one of the following modes:
After pressing the Mode button...
Chime Speaker will...
Chime Speaker beeps and LED flashes
Activate both sound and LED indicator
Chime Speaker beeps
Activate sound only
Chime Speaker LED flashes
Activate LED indicator only
6
Button
7
Nameplate
