3
MOUNTING THE DOORBELL UNIT
The Doorbell unit is mounted by sticking it to a wall using the included adhesive strip.
• Peel off one side of the adhesive strip and attach it to the rear of the backing plate,
ensuring none of it is visible from the front.
• Find the area you want to mount the Doorbell unit. Flat, smooth surfaces are ideal.
Make sure they are clean and dry before mounting.
• Avoid mounting the Doorbell unit on metal surfaces, including UPVC doorframes, as
this may reduce the transmission range.
• Peel off the other side of the adhesive strip and press the Doorbell unit against the
mounting surface for 60 seconds.
MOUNTING THE SPEAKER UNIT
There is no requirement to mount the Speaker unit. You may find it more convenient to
place it on a shelf or table. The operating distance between the Speaker and Doorbell is
up to 50m/165ft but the range may vary depending on local conditions.
If you would like to mount the Speaker, simply attach the two screws to a wall. Place
them level to each other, about 24mm / 15/16” apart. Depending on the surface, you
may need to drill guide holes and/or use masonry plugs or dry wall anchors.
Do not insert the screws all the way. Leave about 7mm / ¼” protruding from the wall.
Then place the unit onto the screws, ensuring the heads of the screws pass through
the two mounting holes on the rear of the unit. You can then shift the unit downwards
to ensure it sits on the screws firmly.
Operating Guide
WARNING: When fitting the screws into the wall, make sure you are not inserting them
anywhere near electrical wires, including wires that may be behind the wall. If you are
unsure at all, please get a professional to check first and install the screws for you.
PAIRING THE DOORBELL WITH THE SPEAKER
1. Press and hold the
Chime Select
button on the Speaker unit until a “Ding-Dong”
sound is heard. The Speaker is now in pairing mode for 30 seconds.
2.
Press the Doorbell button. The Speaker will confirm pairing by playing the chime.
See below for instructions on setting the Speaker volume and chime.
Note: A maximum of 20 Doorbell units can be paired to one Speaker unit.
SETTING THE SPEAKER VOLUME AND CHIME
• To adjust the volume
, press the
Volume
button on the Speaker unit.
Four volume levels, including mute (LED blinking only), are available. You will hear
the difference in volume each time the
Volume
button is pressed.
• To change the chime
, press the
Chime Select
button on the Speaker unit.
The Speaker will play the next tune. Keep pressing the button until you hear a
tune you like. There are 38 tunes to choose from. You do not need to confirm your
selection. The tune playing is the chime selected and the one that will be heard
when the Doorbell is pressed.
RESETTING THE SPEAKER
Press and hold the
Volume
button on the Speaker unit until a “Ding-Dong” sound is
heard. This clears the pairing information. You will need to pair the Doorbell unit again.
