SWAGTRON SWAGCYCLE PRO SCP-1, Руководство пользователя

Страница: 8 / 15

Upper Clamp
Lower Clamp
Upper Clamp
Lower Clamp
Seat Stem
10 11
ENGLISH ENGLISH SWAGTRON SwagCycle Pro Folding Electric Scooter SWAGTRON SwagCycle Pro Folding Electric Scooter
Section 3. Charging Your SwagCycle
™
Pro
Step 1.
Slide the compartment cover to reveal the charging port.
Step 2.
Take out the charging cable from the compartment, next,
connect the one end of the charging cable to the wall
then connect the other end to the charging port.
Step 3.
An indicator inside the compartment will light up based
on the battery status:
– Red:
Charging
– Yellow:
Almost fully charged, the yellow indicator will
flash.
– Green:
Fully Charged
Step 4.
Allow at least 5 hours when charging for the first time.
After this initial charge, average charging time is 3-5
hours.
Step 5.
Once fully charged, slide the compartment cover back
in to prevent water or debris from entering the charging
port or battery. The compartment can be used for cable
management if needed.
Safety tips for charging your battery:
• Fully charge the battery before your first use, this may take up to 5 hours
.
• To maximize the life of the battery, you must charge it after each cycling session.
• When not in active use, please charge at least once a month to maintain optimal battery levels.
• Perform periodic visual inspection of the battery ports and charger cables.
Step 5.
Insert the Upper Clamp into the bottom of the seat one side at a time.
(fig. 5)
Step 6.
Position the seat onto the bike seat stem.
Step 7.
While holding the Barrel Nut in place, manually tighten the Hex Bolts. Repeat with the other Barrel
Nut.
Step 8.
Use the Hex Key to tighten the Hex Bolts in place. Make sure the seat is positioned so that the front
end points towards the stem and the seat surface is level.
(fig. 6)
fig. 5
fig. 6
USB Port
Compartment cover