INSTRUCTION SHEET
PRODUCT:
64692 QUAD 2 + 2 Bike Rack • Page 1 of 3
Swagman • 300 - 1880 Government St. • Penticton, B.C. Canada V2A 7J1 • Phone (250) 490-8883 • Fax (250) 490-8885 • www.swagman.net
REV 05/07/16
2
Assembly Instructions for Quad 2 + 2
1. Remove main assembly from box.
2. For easier assembly, insert the main tube into your 2” Class 3 hitch.
3. Align the ratcheting upright bar assembly onto the center section of
the main assembly (Diagram 1). Position it so that it folds to the left
side when viewing from the back of the vehicle. This will allow for
easier use of the ratchet hooks. Secure with two carriage bolts,
washers and nuts. Do not tighten the bolts completely at this time.
4. The crossbars are in two pieces. You need to insert the male section
into the female section. Make sure that the small set screw holes at
the ends of the bars are both facing downward.
5. Insert the cross bar through the upright ratchet assembly. The square
hole on the bar should face up (Diagram 2). Insert one carriage bolt
through the cross bar and the bracket. Install the second bolt
through the side plate of the ratchet arm assembly (Diagram 3).
Tighten all of the bolts, including the ones on the upright ratchet arm.
6. Install one short hook and one long hook onto the upright ratchet
arm. NOTE: the short hook goes on fi rst (Diagram 4).
7. Repeat steps 1 to 5 for the second ratcheting upright arm and
cross bar.
8. Slide the wheel trays onto the cross bars. The wheel holders should
be installed so the upsweep is facing inward. The orientation of the
bikes will determine the best position for the 8 wheel holders. You
want to make sure the buckle side is facing towards you when you
are at the back of the vehicle. This will allow for easier use of the
buckle and strap. Review
Bike Installation
for more details on
loading bikes.
9. After all of the wheel trays are installed you will need to install the
small screws onto the underside ends of each arm. This will prevent
the wheel trays from sliding off if you forget to tighten the wheel tray
knob (Diagram 5).
Removing the 2 Bike add on section
1. Remove the 10mm Allen bolts with the supplied wrench.
2. Remove the 6mm set screw.
3. Remove the end section.
4. Put the extra end cap on the remaining section of the bike rack.
5. Store the add on section for future use.
Installing the Quad 2 + 2 on to your Vehicle
1. Insert the bike rack into the 2” Class 3 receiver. Install the 5/8”
threaded locking hitch pin and tighten to 50 ft lbs. (very tight). Put
on the lock head until it is securely attached.
1
3
4
5
Short
Long
