SW-Stahl S3213, Руководство пользователя

Страница: 7 / 12

7
S W-S t a h l G m b H w w w. s w s t a h l . d e
O P E R AT I O N S
Before use, drain water out of air compressor tank and condensation from air lines. After clearing air
compressor moisture and lubricating the air hammer, connect it to an air hose of a recommended
compressor.
1. Remove the spring retainer to load a chisel. Always tighten the spring retainer well before use.
WARNING !!! Use attachments designed for use with air tools. Do not use damaged attachments.
2. Depress the trigger to operate. Always hold the hammer well during operation to avoid injury.
A I R S U P P LY
Air supply MUST be greater than air requirement of the tool, Recommended air compressor is 3/4HP.
Air Hose: Using 3 m or 7,5 m long with 5 mm inside diameter and 1/4PT threads is recommended. Ho-
wever, hoses longer than 7,5 m should use 10 mm even 12 mm inside diameter. For proper performance
and more convenience. Using fittings or air hoses which are too small can create a pressure drop and
reduce the power of the air hammer.
WARNING !!! Keep hoses away from heat, oil and sharp edges. Replace any hose that is damaged, weak
or worn. Never carry a tool by the hose or pull the hose to move the tool or a compressor. The use of air
filters and air line lubricators is recommended.
S TO R AG E
The air hammer must be lubricated before storage. Follow the lubrication instructions. Only run for 3
seconds instead of 20 seconds because more oil needs to remain in the tool when storing.
S P E C I F I C AT I O N
Chisel Shank ( Round ) 10.2 mm Bore Diameter (ID) 19,05 mm
Blow per minute 4.500BPM Stroke 43 mm
Air Cons 4CFM / 90 PSI Length 151 mm
Air Inlet 1/4”PT Weight 1.45 KG