SW-Stahl 61805SB, Инструкция по эксплуатации

Страница: 5 / 8

5
6 1 8 0 5 S B
D E S C R I P T I O N
For battery-operated use, ready for use in only about 15 seconds, for the fast and mobile repair
of cold solder spots etc. 4.5 V / 6 W, working temperature approx. 420°C. With 3 AA batteries (not
included in the scope of supply) up to 120 solder spots possible, can also be used with rechargeable
batteries. The working area is optimally illuminated by an LED. The set includes a protective cap,
lead-free solder, soldering tip with removal key.
Diameter shaft 3 mm / tip 0.7 mm.
S A F E T Y N O T E S
1 .
Place the protective cover over the tip when storing such that the cover secures
the slide switch in the “OFF” position.
2 .
Tip is hot. Do not touch. Do not immerse in water!
3 .
After using the soldering iron, cool the iron naturally before storing away.
4 .
Always switch off the soldering iron after use by sliding the switch to the “OFF” position.
Damage caused by non-observance of these operation instructions or by improper repairs is not
covered by our guarantee. We reserve the right to make changes in the interest of technical progress.
O P E R AT I N G I N S T R U C T I O N S
1 .
Slide the battery cover open at the end of the soldering iron
2 .
Place 3 x 1.5V size AA alkaline batteries into the iron as illustrated and replace cover.
3 .
Remove the protective cover at the tip.
4 .
Make sure tip is securely installed.
5 .
Slide the On/Off switch to the “ON” position.
6 .
Hold the soldering iron like a pen.
7.
Press the round button on top of the On/Off switch continuously for approx. 15 seconds.
8 .
The tip should reach working temperature.
9.
To save power, only press button when actually soldering.
1 0 .
The hot soldering iron should be placed standing upright with the tip pointing up when
not in use to avoid contacting the surrounding.
1 1 .
After soldering, slide the switch to the “OFF” position, replace the protective cover.