7
2 3 0 6 0 L
2 . C O M P O N E N T N A M E S A N D S TA N DA R D PA R T S PAC K AG E D
MAIN BODY ------------------------------------------------------------------- 1 UNIT
HEATING REPAIR PIN (V-SHAPED 0.8 mm, 23060L-3) ------------------------------ 100 PCS / BAG
HEATING REPAIR PIN (U-SHAPED 0.8 mm, 23060L-1) ------------------------------ 100 PCS / BAG
HEATING REPAIR PIN (W-SHAPED 0.8 mm, 23060L-2) ----------------------------- 100 PCS / BAG
INSTRUCTION MANUAL -------------------------------------------------------- 1 COPY
3 . S P E C I F I C AT I O N
POWER SOURCE: AC 240V, 60Hz
POWER CONSUMPTION: 10.8W
4 . H O W TO O P E R AT E
1.
Plug in to 240V outlet.
2.
Set the temperature control knob according to the type of plastic.
L ----- Thin plastic (bumper etc.)
M ----- To about 5mm thick plastic (spot light etc.)
H ----- Thick or hard plastic
3.
Turn on the main switch.
4.
Choose suitable heating repair pin and set it to tip of the grip.
5.
Please form the part to repair as original shape.
6.
Presses the switch button on the grip and hold about 10 seconds until the
pin is hot enough to weld. Then press the pin gently against the place to repair.
WARNING
WHEN HEATING REPAIR PIN IS PRESSED TOO HARD, IT MAY PENETRATE
THE OBJECT. PLEASE PRESS BY SLlGHT POWER.
7.
When the pin is taken half way to the repairing part, release the switch button
on the grip then wait for a few seconds until repair part gets fi rm. After that
draw the pin out of the grip.
8.
When a repairing part reaches long and wide, please repeat the procedure
at intervals of 1 - 3 cm.
9.
Cut off the pin using pliers.
CAUTION
BE AWARE OF FRAGMENTS. WEAR SAFETY GOGGLES WHEN YOU CUT OFF PINS.
10.
Grind off the excess of the pins using sander. Apply putty and paint if you
wish to fi nish the surface more fi nely.
23060L-3
V-Shaped 0,8 mm
23060L-1
U-Shaped 0,8 mm
23060L-2
W-Shaped 0,8 mm
