SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
Leverkuser Strasse 65
Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid
E-Mail: [email protected]
B
E
D
IE
N
U
N
G
S
A
N
L
E
IT
U
N
G
/
I
N
S
T
R
U
C
T
IO
N
M
A
N
U
A
L
/
M
O
D
E
D
'E
M
P
L
O
I
4. Do not continue pulling on the wrench after pre-set torque has been reached and the
wrench has been released. Pressure must be taken off the handle and the wrench
allowed to automatically reset itself, continuing to apply pressure after the wrench has
been released, will result in damage to the part being torque by applying more than the
specified amount of torque.
5. Tool is rugged and designed for shop use, but is also a precision measuring
instrument and should be treated as such.
6. Clean wrench by wiping .Do not immerse in any type of cleaner which may affect
special high pressure lube with which the wrench is packed at the factory.
7. This torque wrench was calibrated and tested before leaving the factory and is
accurate to ±3%.
8. The key is only suitable for a permissible torque, which can be found in the table
above.
This is a precisions measuring instrument.
Calibration and servicing must be done regularly and is the owner responsibility.
