www.swstahl.de
SW-Stahl GmbH
An der Hasenjagd 3
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: [email protected]
BEDIEUNUNGSANLEITUNG
/ INSTRUCTION
MANUAL
01420L
Brake bleeding device
for one-person operation, can be used for clutch and steering systems as well as for the
fuel line during filter replacement
•
Compressed air connection: 6 - 12 bar
•
Vacuum 60%
Security advice
Do not touch brake paddels while bleeding the brakes. Maintenance and cleaning after
use are recommended. Also check car manufacturers advices.
Use instructions
With this brake bleeder, one person can carry out the bleeding of the brake systems.
The bleeding is done simply, quickly and clean. The brake fluid is sucked into the
container, hereby spilling is avoided.
1. Connect gun to air compressor
2. Set the brake bleeder rubber pipe on the brake system plug, and loosen the plug
3. Activate the handle of the brake bleeder, a partial vacuum is created in the break
bleeder container, and the fluid flushes into it
4. When the fluid is free of air bubbles, which you can see through the clear hose,
tighten the bleeding plug and remove the rubber pipe
5. Repeat procedure for each brake cylinder/calibre
6.
REMEMBER
to check fluid level
