Page 25
N2000 Series User Manual
www.svsiav.com
Chapter 2. Installation
Step-by-Step Installation Instructions
STEP 3
CONNECTING ENCODERS TO THE NETWORK AND
CONFIGURING STREAM SETTINGS
1. Using a Cat-5 cable, connect your SVSi Encoder’s
P0
port to a PoE-enabled switch. In non-
PoE applications connect a 12V regulated power supply (N9312) to the two-pin terminal block
plug connector (labeled
+12V 2A
).
2. In
N-Able
, select the
Unit
Management
tab and click the
Auto
Discover
button (if the table
has not already populated itself with the installed units). See
.
Figure 2-6. Unit Management Page
3. Find your Encoder in the list. N2000 units are displayed on the following tabs:
•
Unit
Management
tab — N2000 units have
N2000 Encoder/Decoder
listed in their
Type
fields.
•
Video Matrix
tab — N2000 units are found on the
N2000
sub-tab (as shown in
).
Note: In order for the unit to receive PoE, it must be connected to a switch or other equipment
that has a PoE PSE port.
Note: If using multiple Encoders in your set up, it is important to plug in and configure one
Encoder at a time. All Encoders come pre-configured to use stream 1. As you add Encoders
to the network, you will need to set them up to use different streams.
