6. INSTALLATION
The following steps explain how to install the UPS to your PC.
Step 1.
Assure AC power source output voltage is in the UPS. Require range which specify on the rear panel.
Step 2.
Plug the UPS power cord into a wall outlet or other Power source.
Step 3.
Plug the personal computer (PC) into the UPS output.
Step 4.
Start the UPS by pressing the ON/OFF button. The AC power green LED indicator illuminates indicating that power is available
from the rear receptacles.
Step 5.
Shutdown the UPS by pressing ON/OFF button.
Caution:
Do not connect a laser printer to the outlets. These UPS outlets provide battery power and surge protection to the equipment when
utility voltage is outside acceptable limits.
6.1. REPLACING THE BATTERY
Note:
Once the battery is disconnected, the loads are not protected from power outages.
Use a cross-type screwdriver to remove the two front panel screws and slide down the panel.
Gently Pull the battery out of the UPS.
Loosen the black wire from the negative (-) terminal and red wire from the positive (+) terminal.
Connect the battery leads to the new battery.
Note:
Small sparks at the battery connectors are normal during connection.
Slide the battery into the UPS.
Close the front panel and fasten two screws.
Dispose of the old battery properly at an appropriate recycling facility.
13
Eng
SVEN Power Pro+ 1000/1500
Step 2
Step 1
Step 3
Step 4
Содержание Power Pro+ 1000
Страница 16: ......
