ENG
2.1 Multimedia Speaker System
4
Fig. 2. Connection diagram
5. PREPARATION AND OPERATION
Speaker placement
•
Place the satellites symmetrically to the listener at the distance not less than one meter.
•
Place MSS far away from monitors and TV sets, as insignificant image distortion in these super-
sensitive devices is possible. We recommend that the subwoofer should be placed on the table.
Installation and operation guide
WARNING! All the components should be switched off before connection.
•
Connect the built-in audio cables to the audio outputs on the rear panel of subwoofer (see Fig. 2).
Note that the red RCA-jack on the right speaker should be connected to subwoofer red terminal and
the white RCA-jack of the left speaker – to the white terminal of the subwoofer AUDIO OUTPUT R/L.
•
Insert the mini-jack of the stereo signal cable into the AUDIO INPUT of the subwoofer, and the other
mini-jack into the Ø 3.5 mm LINE OUT port of your computer sound card or the audio output of your
CD or MP3 player, as shown in Fig.2.
•
Plug the power cord
h
(Fig. 1) on the subwoofer rear panel into a mains outlet.
•
Set the master volume to its minimum by turning the VOLUME knob
a
counterclockwise until it stops.
•
Turn the power supply on with the POWER switch
f
(ON position) on the subwoofer rear panel. The
power LED
d
will illuminate.
•
Turn on your audio source.
•
Adjust the master volume with the VOLUME knob
a
. To increase the volume, turn the knob clockwise;
to reduce the volume, turn it counterclockwise.
