ENG
8
2.1 Multimedia
Speaker System
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If an item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose only the item name and the “connect” command
on the source.
Tuner Mode
•
To switch to the Tuner mode, use the INPUT
b
button on the front panel or INPUT button
a
on the remote control.
•
To auto scan and memorize the found stations, press button
e
on the front panel or the AUTO
n
button on the remote control short. To stop auto scanning, press this button again before
the scanning is over. The display
a
will show the frequency being scanned. When the channel
is being memorized, the display shows its number for a short moment.
•
For manual scanning, use buttons TUNE-/+
c
on the remote control (up/down the frequency
range). To save the selected station, press the SAVE
r
button on the remote control and then,
using buttons
c
and
f
on the front panel or buttons
d
and
m
on the remote control, assign
the station its number and press the SAVE button again. When the station has been memorized,
the display
a
will write “Good”.
•
If preset stations are available in the memory, you can switch from one to another by short
pressing buttons
c
,
f
on the front panel or buttons
d
,
m
on the remote control. You can also
enter the frequency or the number of the preset station with the remote control numeric pad
buttons
g
. The display will show the station number for a short moment and then its frequen-
cy. The radio will tune to the set frequency within 2-3 seconds.
AUX/PC Mode
•
To switch to the AUX/PC mode, press the INPUT
b
button on the front panel or button INPUT
a
on the remote control, the MSS switched on. The display
a
will show AUX or PC.
Clock Mode
•
When the MSS is in the ST-BY mode, the display a shows the current time. When the system
is in a different mode, to see the time, use the CLOCK
j
button on the remote control. The cur-
rent time will show for 3-5 seconds.
•
To set the current time, go to the ST-BY mode by pressing button
e
on the front panel or button
q
on the remote control long. To enter the time setting mode, press the SET
l
button on the remote
control (the corresponding position will start blinking on the display
a
). Set the minutes and hours
directly from the RC numeric pad or using buttons
c
,
f
on the front panel or
d
,
m
on the RC.
To switch between setting hours/minutes and to exit the setting mode, press the RC SET
l
button short.
ST-BY Mode
•
To enter/exit this mode, press and hold down button
e
on the front panel or button
q
on the RC.
When the MSS is in the ST-BY mode, the display a shows the current time.
SLEEP Mode
•
The SLEEP mode enables to switch over the device in the ST-BY mode after a lapse of time
chosen by a user. Press button
p
on the remote control to enter the SLEEP mode. To leave
the SLEEP mode, press button
p
on the remote control once again, while there is “0” character
on the display.
MUTE Mode
•
To enter the MUTE mode, press button
o
on the remote control. To exit the MUTE mode,
press this button again.
