ENG
8
2.1 Multimedia
Speaker System
•
For manual scanning, use buttons TUNE-/+
c
on the remote control (up/down the frequency
range). To save a selected frequency, press SAVE button
r
on the remote control, then using
buttons
e
,
f
on the front panel of the subwoofer or buttons
d
,
m
on the remote control select a
cell number to save and press the SAVE button once again. When saving, the display
a
will show
the message “Good”.
•
If preset radio stations are available in the memory, you can switch from one to another by long
pressing buttons
e
,
f
on the front panel of the subwoofer or buttons
d
,
m
on the remote
control. You can also enter the frequency or the number of the preset station using numeric pad
buttons
g
on the remote control. The display
a
will show the station number for a short moment
and then its frequency. The radio will tune to the set frequency within 2-3 seconds.
AUX Mode
•
Press button
b
on the front panel of the subwoofer or AUX button
e
on the remote control to
switch to the AUX mode. The display
a
will show «AUX» inscription.
ST-BY Mode
•
To enter/exit «ST-BY» mode press and hold button ST-BY
b
front panel of the subwoofer or
button
q
on the remote control. To exit «ST-BY» mode press ST-BY
b
on the front panel of the
subwoofer or button
q
on the remote control.
SLEEP Mode
•
The SLEEP mode enables to switch over the device in the ST-BY mode after a lapse of time
chosen by a user. Press button
p
on the remote control to enter the SLEEP mode. To leave the
SLEEP mode, press button
p
on the remote control once again, while there is “0” character on
the display.
MUTE Mode
•
To enter the MUTE mode, press button
o
on the remote control. To exit the MUTE mode, press
this button
o
once again, or press volume button.
Note. Due to the constant development of the software, the actual MSS operation may
differ from described in this Manual. The most recent version of the Manual is available on
www.sven.fi.
Fig. 6. Bluetooth module connection diagram
