ENG
7
MS-2020
Operation Manual
•
In order to have the high-fidelity reception orient the antenna in direction of radio signal when
listening to the radio, first connecting the antenna to ANTENNA jack
g
.
•
When the MSS operation is over, mind to switch it off using switch
k
(OFF position) and unplug
the power cord
j
from the socket.
6. OPERATION MODES
Player Mode
•
The system will enter the Player mode automatically when a carrier (USB flash or SD card)
is connected to corresponding ports
l
or
m
, or press SOURCE button
b
on the front panel
of the subwoofer or SOURCE button
b
on the remote control.
•
To select a track, you can directly enter its number on the remote control using the numeric
pad buttons
i
or select it with the buttons
c
or
f
on the front panel. The display
a
will show
the track number for a short time and then the playback time elapsed.
Bluetooth Mode
•
In order to transmit signal in this mode it is necessary at first to connect the device with a signal
source (see Fig. 6). For this purpose select the Bluetooth mode using SOURCE button
b
on
the front panel of the subwoofer or SOURCE button
b
on the remote control. The speaker system
will enter the search mode «bt» mode will be shown on the display
a
.
•
It is necessary to select the search mode of devices with Bluetooth on a signal source (telephone,
notebook, smartphone, etc.). «SVEN MS-2020», message will be displayed on the screen which
it should be connected to*.
•
The «bt» lights continuously when connection is successful. If there is no connection, lettering
«bt» will blink. In this case the system should be switched over to the search mode once again (turn
off and turn on Bluetooth mode)**.
Radio Mode
•
Use SOURCE button
b
on the front panel of the subwoofer or SOURCE button
b
on the remote
control to enter the Radio mode. The display
a
will backlight the current adjustment frequency.
•
Press and hold SCAN button
e
on the front panel of the subwoofer or button AUTO
g
on the remote control short to auto scan and memorize the found stations. The display
a
shows
the frequency being scanned, when a radio station is being memorized, the display shows its
assigned sequence number for a short moment.
•
For manual scanning, use buttons TUNE -/+
d
on the remote control (up/down the frequency
range).
•
To store a radio station in memory, short pressing button SAVE
l
on the remote control, then
select the cell with the buttons
f
,
h
and again briefly presses button SAVE
l
.
•
If preset radio stations are available in the memory, you can switch from one to another by short
pressing buttons
c
and
f
on the front panel of the subwoofer or buttons
f
and
h
on the remote
control.
* You might have to enter “0000” code to connect some models via Bluetooth.
** If an item has been already registered in the device list of sources, then the second search mode
activation is not needed. Choose only the item name and the “connect” command on the source.
