
–
–
+
d
d
e
f
g
h
c
a
b
i
l
k
n
p
o
m
j
1
2
3
4
5
6
9
8
7
+
TUNE-
TUNE+
CH+
CH-
SA E
V
A
O
UT
VOL
EQ
MUTE
AUX
USB
FM
SD
0
RESET
REPEAT
Fig. 3. Remote control
l
CH+/ : next track (pressed short in the Player mode)
next station* (pressed short in the Tuner mode)
m
AUTO: start auto scanning and memorizing stations in FM
band (in the Tuner mode)
n
VOL+/-: volume control
o
SAVE: memorize selected frequency
(in the Tuner mode)
p
RESET: return to default settings
Note. Before operating insert the batteries (included) into
the remote control.
* The frequencies are switched if there are stations preset in the
memory.
** The storage device must be formatted as FAT, FAT32. Memory cards
SDHC class 10 or less can be used. Connecting devices other than
USB
fl
ash drive is not recommended. Connection of HDDs and other
devices can cause damage to the MSS.
5. PREPARATION AND OPERATION
Speaker placement
•
Place the speakers symmetrically to the listener at least one me-
ter away. The subwoofer emits non-directional sound, therefore it
can be located in any place of the room where it sounds the best.
•
Place MSS far away from monitors and TV sets, as insigni
fi
cant
image distortion in these supersensitive devices is possible.
Installation and operation
MS-1820 speaker system can be connected to virtually any audio
devices: DVD/CD players, PCs, laptops, etc. (see diagram in Fig. 4).
Warning! Before connection all components of the system
must be turned off.
•
Connect satellites with the subwoofer using built-in acoustic cables in speakers. Connect the left
speaker to the OUTPUT L
o
jack and the right speaker to the subwoofer OUTPUT R
n
jack (see
diagram in Fig. 4).
•
To connect the MSS to a PC,
МР
3/CD player, use a 2RCA to mini-jack signal cable (included).
Insert the RCA jacks of the signal cable into the L
l
and R
m
jacks of the INPUT, and the mini-jack
of the signal cable – into the LINE OUT port of your PC sound card or an audio output of your
МР
3/
CD player.
•
To connect the MSS to a TV or DVD/CD player, use a 2RCA to 2RCA signal cable (not included).
Insert the RCA jacks of the signal cable into the L
l
and R
m
jacks of the INPUT, and the other RCA
jacks – into your TV or DVD/CD player audio output jacks, as shown in Fig. 4.
Note. Check the reliable
fi
xation of wires in the terminals, polarity of connection and absen-
ce of contact of the bared wires with each other and the metal parts of the hardware.
4
ENG
2.1 Multimedia Speaker System