Sven GC-W600, Руководство по эксплуатации

Страница: 19 / 23

Fig. 6
7. CONNECTION AND INSTALLATION
Install the device on even surface (for example,
on a table) on its 8 suction caps.
!
Connect pedal unit (Fig. 2) to the device via
cable of the pedal unit to RJ-11 jack
n
, then
connect USB cable
o
of the device to the USB
port of the computer.
!
Insert Software CD disk into the disk drive of
your PC and launch «Driver.exe» to install drivers
on your PC.
In order to check and adjust the steering
wheel, you need to open the «Devices and
printers» tab in the Windows control panel (in the
«XInput» mode, the steering wheel is displayed
as «Xbox 360 Controller for Windows», in the
«DirectInput» mode - «PS3 / PC Gamepad»),
then right-click on the device icon and select
«Game Device Settings» (administrator rights
may be required) (Fig.4,5). The «Game devices»
!
window will appear. In XInput mode, the steering
wheel is displayed as «Controller (Controller (XBOX 360
For Windows))» (Fig. 6), in the «DirectInput» mode -
«LS-USBMX 1/2/3 Steering ..." (Fig. 7) . To switch
between the «DirectInput» and «XInput» modes, you must
press the «Mode» button for 5 seconds.
To check and con gure in XInput mode, select
«Properties» in the «Game devices» window, the
«Properties: Controller (XBOX 36 ...» window will pop-up
(Fig.8). In the «Veri cation» tab you can check the
execution commands when you press the buttons and
rotate the rudder To calibrate the rudder, select the
«Settings» tab, click «Calibrate» and follow the
instructions.
!
To check and con gure in DirectInput mode, select
Properties in the Game Devices window, and the Properties
window: LS-USBMX1 / 2/3 Steering ... pops up. In the
«Base Test» tab, you can check the execution of commands
when you press the buttons and rotate the rudder, and also
check the correct connection of the rudder to the PC in the
«Connected State» line (Fig. 9).
Fig. 4
Fig. 5
Fig. 7
ENG
Operation Manual
19
GC-W600