VIS101-TX
5
INSTALLATION
Powering On the Motion Sensor
The motion sensor requires 4 AA batteries to operate. Please see instructions on how to install batteries and mount
your motion sensor properly.
• Once you have successfully installed the batteries in the motion sensor, the sensor will start up automatically,
please allow 60 seconds for the unit to initialize before it will begin sensing motion and sending signals
• It will be necessary to pair the motion sensor and the receiver before any alarms are received (see Pairing the
Devices below)
Installing Batteries in the Sensor Unit
This unit requires 4 AA batteries to operate. The unit is designed to operate on batteries for 6 months or longer
before they will need to be replaced. This length of time could be shortened somewhat if you have a larger than
average amount of alarms set off every day.
1. Remove the battery compartment cover on the back of the sensor unit using a small phillips head screwdriver.
2. Install 4 AA batteries.
3. While you have the compartment cover off, you should adjust the sensitivity to your needs, (see Setting the
Sensor Sensitivity on Page 6) and pair the sensor to the proper zone, if you have not already done so (see
Pairing the Devices below).
4. Replace the battery compartment cover.
Pairing the Devices
The sensor must be paired with a receiver before the sensor can send alerts.
1. Power on both units, press the pair button on the right side of the receiver.
2. The receiver will beep once and the first zone LED will blink. Choose which sensor you would like to monitor
zone 1, and press the pair button inside the battery compartment of that sensor unit.
3. The receiver unit will beep twice and the chosen zone LED will stop flashing when the units have been paired.
4. To connect additional sensors, press the pair button on the receiver and choose a zone by pressing one of the
zone buttons. The zone button will begin blinking. Press the pair button inside the battery compartment of
the sensor you wish to pair.
5. The receiver unit will beep twice and the chosen zone LED will stop flashing when the units have been paired.
6. If you are finished pairing the devices you can press the power button on the receiver to exit pair mode.
7. Always test that the system will receive alerts before installing the sensor unit by waving your hand or walking
past it until you receive an alert.
Pair Buttons
Sensor
Receiver (Not Included)
