SVAT CLEARVU1, Инструкция по эксплуатации, Страница: 10 / 76

2-4: POWERING ON
1. Insert the power supply wire into the rear DC 12V Port on the DVR.
2. Insert the power cord into the power supply.
3. Plug the power cord into a power outlet. We recommend using a surge protected power bar
and/or UPS backup (to turn the DVR on and off, use the power switch on your UPS or
power bar).
4. The DVR will power on and you will see a boot screen. After the DVR initializes you should
see a 4 camera QUAD view, and recording will begin immediately.
SVAT ELECTRONICS
now you can see
CLEARVU1 7
POWER SUPPLY
POWER CORD
DC 12V PORT
1. We strongly recommend that you change the following settings as soon as you
power on the DVR ( see section 4-4-5 for detailed instructions):
(A) Set up the time/date.
(B) Go to the HDD management and FORMAT HDD. This will clear the video you
recorded after power on and avoid any time/date discrepancies.
2. DO NOT change the date and time after the recording starts. It may corrupt the
DVR’s data archive and cause playback errors. If it is necessary to change date and
time after the recording starts, please repeat step 1 to avoid errors.