INSTRUCTIONS OF ASSEMBLY METHOD
1.Open the fan of the packaging to examine the integrity of parts, as above
diagram;
2. First, put the two gaskets into the support tubes, and then insert into the
corresponding holes of the base, (such as the A section of installing the base
components shown) use the screw with a screw meson to tighten the support
tubes. Finally the four casters should be installed to the alignment holes at the
base, tightening with a special wrench,and then put on the decorative base
cover
3.Take out of the Fan Head (this part has been installed before leaving the
factory),unscrewethe two tightening button to put it into the installed support
tube.
4.Take out of the Guard Fastening Screw and tighten the Rear Guard on
Clockwise in Fan Head;
5.Take the blade and tighten it with the Blade Fastening Screw by
Counterclockwise on the motor shaft;
6. Finally tighten the Front Guard, first unscrewe the screw of Hoop Net a little,
align and hoop the Front Guard and Rear Guard then tighten the screw,
Fan components are assembled completely.
Using of Water Tank Diagram as follows:
MAINTENANCE OF COOL HUMIDIFIER
Unplug the unit before cleaning.
Cleaning of water tank (once a week)
If there is dirt in the water tank, clean it with detergent and flush it with clean
water.
Cleaning of Humidifier outside:
