Security VIP
Global Technology STRC-600 Quick Start
http://www.s-vip.com
Security VIP
Global Technology STRC-600 Quick Start
http://www.s-vip.com
2 of 4
Controls
Antenna
Energy wires
Microphone
LED
3 of 4
Power supply
It is necessary to use a source of the direct current with the voltage from 6VDC to
14VDC. At connection of the power supply observe polarity.
Wire with
white
marking is
“PLUS”!
It is recommended to use batteries or rechargeable batteries.
At connection of the
power supply to STRC-600 use wires of the minimal length.
Battery monitoring
When the battery voltage drops low, STRC-600 will be work until the possible
discharge but you will be hearing the beeps on a background sound.
Using STRC-600 with STV-02.
Before using STV-02, read “STV-02 COMBO RECEIVER Quick
start”!
Before turning on STRC-600, straighten the antenna! It is necessary in
order to achieve maximum range of the work.
Also it is necessary to switch STV-02 to the analog mode (press
[F]
[7]
).
/In the analog mode, the symbol “R” is displayed. This is default mode./
STRC-600 transmitter setting-up procedures
In order to make the transmitter ready for the operating with the receiver, following
next steps:
1.
Select the memory channel.
2.
Set the analog mode of the receiver.
3.
Set the desired frequency
(the frequency range of STRC-600 is limited
within the limits of from 400.000 MHz up to 440.000 MHz !)
.
4.
Connect the power supply (
6 - 14VDC
) to the transmitter.
5.
Press and hold down for
1 sec
. the
[REV]
key. The memory channel
number starts blinking.
6.
Place antenna of STV-02 in immediate proximity from STRC-600.
7.
Press the
[Transmitter ON]
key. The control word is transmitted to the
STRC-600 during
6 sec
. The green color of the “TX/BAT” lamp indicates
the transmitting. The green LED on the PCB of STRC-600 must shine
during short time.
[CALL]
– to cancel setting-up procedures (if Step 7 was not performed the
transmitter STRC-600 will not be reprogrammed).
