Security VIP
Global Technology STRC-600 Quick Start
http://www.s-vip.com
4 of 4
Activation the transmitter.
Connect the power supply (
6 - 14VDC
) to the transmitter.
The green LED on the PCB of STRC-600 must shine during short time.
For getting of the best quality of a sound it is recommended to use Tone control in
STV-02.
/Press [F] [4] for treble control. [UP]/[DOWN] – to select treble level. [F] – to accept selection.
[CALL] – to cancel.
Press [F] [5] for bass control. [UP]/[DOWN] – to select bass level. [F] – to accept selection. [CALL] –
to cancel./
Deactivation the transmitter.
Disable the power supply.
Changing operating frequency
Enter a frequency, following preceding sections “
Entering a frequency
” and
“
Changing frequency, using
[UP] [DOWN]
key
” from
“STV-02 COMBO
RECEIVER Quick start”.
The frequency range of STRC-600 is limited within the limits of from 400.000
MHz up to 440.000 MHz !
Transmitting new operating frequency to the STRC-600
1.
Connect the power supply (
6 - 14VDC
) to the transmitter.
2.
Press and hold down for
1 sec
. the
[REV]
key. The memory channel
number starts blinking.
3.
Place antenna of STV-02 in immediate proximity from STRC-600.
4.
Press the
[Transmitter ON]
key. The control word is transmitted to the
STRC-600 during
6 sec
. The green color of the “TX/BAT” lamp indicates
the transmitting. The green LED on the PCB of STRC-600 must shine
during short time.
[CALL]
– to cancel setting-up procedures (if Step 4 was not performed the
transmitter STRC-600 will not be reprogrammed).
Security VIP
Global Technology STRC-600 Quick Start
http://www.s-vip.com
1 of 4
STRC-600 ANALOG MINITRANSMITTER
Quick start
