Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 76 / 1257

1A-28 Engine General Information and Diagnosis:
CLOSED THROTTLE POS (CLOSED THROTTLE
POSITION, ON/OFF)
This parameter reads ON when throttle valve is fully
closed, or OFF when it is not fully closed.
CANIST PRG DUTY (EVAP CANISTER PURGE FLOW
DUTY, %)
This parameter indicates valve ON (valve open) time
rate within a certain set cycle of EVAP canister purge
valve which controls the amount of EVAP purge.
IGNITION ADVANCE (IGNITION TIMING ADVANCE
FOR NO.1 CYLINDER,
q
)
Ignition timing of No.1 cylinder is commanded by ECM.
The actual ignition timing should be checked by using
the timing light.
BATTERY VOLTAGE (V)
This parameter indicates battery positive voltage
inputted from main relay to ECM.
FUEL PUMP (ON/OFF)
ON is displayed when ECM activates the fuel pump via
the fuel pump relay switch.
ELECTRIC LOAD (ON/OFF)
ON: Headlight or small light ON signal inputted.
OFF: Above electric loads all turned OFF.
BRAKE SW (ON/OFF)
This parameter indicates the state of the brake switch.
RADIATOR COOLING FAN (RADIATOR COOLING
FAN CONTROL RELAY, ON/OFF)
ON: Command for radiator cooling fan control relay
operation being output.
OFF: Command for relay operation not being output.
BLOWER FAN (ON/OFF)
This parameter indicates the state of the blower fan
motor switch.
A/C SWITCH (ON/OFF)
ON: Command for A/C operation being output from ECM
to HVAC.
OFF: Command for A/C operation not being output.
A/C COMP RELAY (A/C COMPRESSOR RELAY, ON/
OFF)
This parameter indicates the state of the A/C switch.
VEHICLE SPEED (km/h)
It is computed based on pulse signals from vehicle
speed sensor.
VVT GAP (TARGET-ACTUAL POSITION,
q
)
It is calculated using the formula: target valve timing
advance – actual valve timing advance.
Visual Inspection
S4RS0A1104008
Visually check the following parts and systems.
Inspection item Reference section
• Engine oil – level, leakage “Engine Oil and Filter Change: in Section 0B”
• Engine coolant – level, leakage “Coolant Level Check: in Section 1F”
• Fuel – level, leakage “Fuel Lines and Connections Inspection: in
Section 0B”
• Air cleaner element – dirt, clogging “Air Cleaner Filter Inspection: in Section 0B”
• Battery – fluid level, corrosion of terminal “Battery Description: in Section 1J”
• Water pump belt – tension damage “Accessory Drive Belt Inspection: in Section
0B”
• Throttle cable – play (under warm engine), installation “Accelerator Cable Adjustment: in Section
1D”
• Vacuum hoses of air intake system – disconnection, looseness,
deterioration, bend
“Vacuum Hose Inspection: in Section 1B”
• Connectors of electric wire harness – disconnection, friction
• Fuses – burning
• Parts – installation, bolt – looseness
• Parts – deformation
• Other parts that can be checked visually
Also check the following items at engine start, if possible
• Malfunction indicator lamp – Operation
“Malfunction Indicator Lamp (MIL) Check: ”
• Charge warning lamp – Operation “Generator Symptom Diagnosis: in Section
1J”
• Engine oil pressure warning lamp – Operation “Oil Pressure Switch Inspection: in Section
9C”
• Engine coolant temp. meter – Operation “Engine Coolant Temperature (ECT) Sensor
Inspection: in Section 9C”
• Fuel level meter – Operation “Fuel Level Sensor Inspection: in Section 9C”