Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 439 / 1257

Rear Suspension: 2C-9
6) Install brake back plates (1), spindles (2) and new
spindle bolts (a) and then tighten spindle bolts (a) to
specified torque.
CAUTION:
Do not reuse (reinstall) removed rear spindle
bolts (a).
Tightening torque
Rear spindle bolt (a): 75 N·m (7.5 kg-m, 54.0 lb-
ft)
7) Connect wheel speed sensors (1) and lead wire
clamps (2) (right & left) (if equipped with ABS).
Tightening torque
Wheel speed sensor bolt (a): 11 N·m (1.1 kg-m,
8.0 lb-ft)
8) Connect brake pipes to wheel cylinders (1) (right &
left) and tighten brake pipe flare nuts (a) to specified
torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kg-m, 11.5
lb-ft)
9) Connect brake flexible hoses (1) to bracket on rear
axle with E-rings (3) (right & left) and tighten brake
pipe flare nuts (a) to specified torque.
Tightening torque
Brake pipe flare nut (a): 16 N·m (1.6 kg-m, 11.5
lb-ft)
10) Install wheel speed sensor clamp and parking brake
clamp and tighten parking brake clamp bolts (1) to
specified torque.
Tightening torque
Parking brake cable clamp bolt (a): 11 N·m (1.1
kg-m, 8.0 lb-ft)
11) Install brake drums (right & left). For details, refer to
Steps 2) – 7) of “Rear Brake Drum Removal and
Installation: in Section 4C”.
12) Fill reservoir with brake fluid and bleed brake
system. For bleeding operation, see “Air Bleeding of
Brake System: in Section 4A”.
1
2
I4RS0A230024-
I4RS0A230025-
1 (a) 2
I4RS0A230026-
(a)
1
I4RS0A230027-
I4RS0A230028-
1, (a)
I4RS0A230029-