Suzuki SWIFT RS415 2017, Руководство по обслуживанию

Страница: 340 / 1257

1F-1 Engine Cooling System:
Engine Cooling System
General Description
Cooling System Description
S4RS0A1601001
The cooling system consists of the radiator cap, radiator,
coolant reservoir, hoses, water pump, cooling fan and
thermostat. The radiator is of tube-and-fin type.
Coolant Description
S4RS0A1601002
WARNING:
• Do not remove radiator cap to check
engine coolant level; check coolant
visually at the see-through coolant
reservoir. Coolant should be added only to
reservoir as necessary.
• As long as there is pressure in the cooling
system, the temperature can be
considerably higher than the boiling
temperature of the solution in the radiator
without causing the solution to boil.
Removal of the radiator cap while engine is
hot and pressure is high will cause the
solution to boil instantaneously and
possibly with explosive force, spewing the
solution over engine, fenders and person
removing cap. If the solution contains
flammable anti-freeze such as alcohol (not
recommended for use at any time), there is
also the possibility of causing a serious
fire.
• Check to make sure that engine coolant
temperature is cold before removing any
part of cooling system.
• Also be sure to disconnect negative cable
from battery terminal before removing any
part.
The coolant recovery system is standard. The coolant in
the radiator expands with heat, and the coolant is
overflowed to the reservoir.
When the system cools down, the coolant is drawn back
into the radiator.
The cooling system has been filled with a quality coolant
that is a 50/50 mixture of water and ethylene glycol
antifreeze.
This 50/50 mixture coolant solution provides freezing
protection to –36
q
C (–33
q
F).
• Maintain cooling system freeze protection at –36
q
C (–
33
q
F) to ensure protection against corrosion and loss
of coolant from boiling. This should be done even if
freezing temperatures are not expected.
• Add ethylene glycol base coolant when coolant has to
be added because of coolant loss or to provide added
protection against freezing at temperature lower than
–36
q
C (–33
q
F).
NOTE:
• Alcohol or methanol base coolant or plain
water alone should not be used in cooling
system at any time as damage to cooling
system could occur.
• Coolant must be mixed with deminerated
water or distilled water.
Anti-freeze proportioning table
Coolant capacity
• For M/T vehicle
Engine, radiator and heater: 5.5 liters (11.62/9.68
US/lmp pt.)
Reservoir: 0.7 liters (1.48/1.23 US/lmp pt.)
Total: 6.2 liters (13.10/10.91 US/lmp pt.)
• For A/T vehicle
Engine, radiator and heater: 5.4 liters (11.41/9.50
US/lmp pt.)
Reservoir: 0.7 liters (1.48/1.23 US/lmp pt.)
Total: 6.1 liters (12.89/10.74 US/lmp pt.)
For M/T
vehicle
For A/T
vehicle
Freezing temperature
q
C –36 –36
q
F –33 –33
Anti-freeze / Anti-
corrosion coolant
concentration
% 50 50
Ratio of compound to
cooling water
ltr. 3.10/3.10 3.05/3.05
US pt. 6.55/6.55 6.44/6.44
Imp pt. 5.46/5.46 5.37/5.37