23
ENGINE COOLANT
The engine coolant level should be kept between the
“FULL” and “LOW” level lines as shown in the photo-
graph.
Inspect the level with the vehicle held upright on level
ground.
A: Engine coolant reservoir
B: “FULL” level line
C: “LOW” level line
If the level is lower than the “LOW” level line, add the
properly mixed engine coolant as follows.
1. Remove the fastener to take off the side cover.
A: Side cover
B: Fastener
C: Fastener
D: Fastener
2. Remove the reservoir tank cap and add 50 : 50 mix-
ture of engine coolant and distilled water to the
“FULL” level line from the engine coolant filler hole.
3. Reinstall the reservoir tank cap.
E: Reservoir tank cap
4. Reinstall the side cover.
A: Side cover
B: Fastener
C: Fastener
D: Fastener (Large)
NOTE:
To remove the fastener
B
, push in the center
pin and pull out the fastener.
To remove the fastener
C D
, pull out the cen-
ter pin and pull out the fastener.
NOTE:
To install the fastener, pull the center pin and
fix the fastener by pushing the center pin.
