5-14
10. Mark the top dead center position
on the “cap type” filter wrench or
on the oil filter. Use an oil filter
wrench to tighten the filter 2 turns
or to specified torque.
Oil filter tightening torque:
20 N·m (2.0 kgf-m, 14.5 lb-ft)
11. Reinstall the drain plug and
tighten it securely. Pour about 2.7
L (2.9/2.4 US/Imp. qt) of the speci-
fied oil in the filler hole. (See
“FUEL, OIL AND ENGINE COOL-
ANT RECOMMENDATION” sec-
tion).
12. Start the engine (while the vehicle
is outside on level ground) and
allow it to idle for a few minutes.
13. Turn the engine off and wait for
three minutes. Recheck the oil
level with the engine oil dipstick.
The oil level should be at the “F”
(full) mark. If it is lower than the
“F” mark, add oil until it reaches
the “F” mark. Inspect the area
around the drain plug and oil filter
for leaks.
Mark top dead center
Oil filter wrench
In the position at
which the filter
gasket first contacts
the mounting
surface.
Tighten the filter
2 turns or
to specified torque.
CAUTION
Failure to use the correct oil can
damage your ATV.
Engine damage may occur if you
use oil that does not meet
Suzuki’s specifications.
Be sure to use the oil specified in
the FUEL, OIL AND ENGINE
COOLANT RECOMMENDATION
section.
Содержание LT-A450X 2006
