Suzuki GN125F, Руководство по обслуживанию, Страница: 129 / 148

SERVICING INFORMATION
7-1
TROUBLESHOOTING
ENGINE
Remedy Symptom and possible causes Complaint
Engine will not start
or is hard to start.
Engine stalls easily
Noisy engine
Slipping clutch.
1. Clutch control out of limit or loss of play.
2. Weakened clutch springs.
3. Worn or distorted pressure plate.
4. Distorted clutch plates, driven and drive. Adjust.
Replace.
Replace.
Replace.
Compression too low
Plug not sparking
No fuel reaching the carburetor
1. Valve clearance out of limit.
2. Worn valve guides or poor seating of valves.
3. Valves mistiming.
4. Piston rings excessively worn.
5. Worn-down cylinder bore.
6. Poor seating of spark plug.
7. Starting motor cranks but too slowly.
1. Fouled spark plug.
2. Wet spark plug.
3. Defective trigger coil.
4. Defective ignitor unit.
5. Defective ignition coil.
1. Clogged hole in the fuel tank cap.
2. Clogged or defective fuel cock.
3. Defective carburetor float needle valve.
4. Clogged fuel pipe.
5. Clogged fuel filter.
Adjust.
Repair or replace.
Adjust.
Replace.
Replace or rebore.
Retighten.
Consult "electrical complaints"
Clean or replace.
Clean and dry.
Replace.
Replace.
Replace.
Clean.
Clean or replace.
Replace.
Clean or replace.
Clean or replace.
1. Fouled spark plug.
2. Defective trigger coil.
3. Defective ignitor unit.
4. Clogged fuel pipe.
5. Clogged jets in carburetor.
6. Valve clearance out of limit.
7. Clogged fuel filter.
Clean.
Replace.
Replace.
Clean.
Clean.
Adjust.
Clean or replace.
Excessive valve chatter
Noise appears to come from piston
Noise seems to come from clutch
Noise seems to come from crankshaft
1. Valve clearance too large.
2. Weakened of broken valve springs.
3. Worn down rocker arm or rocker arm shaft.
1. Piston or cylinder worn down.
2. Combustion chamber fouled with carbon.
3. Piston pin or piston pin bore worn.
4. Piston rings or ring groove worn.
1. Worn splines of countershaft or hub.
2. Worn teeth of clutch plates.
3. Distorted clutch plates, driven and drive.
4. Clutch damper weakened.
1. Worn of burnt bearings.
2. B g-end bearings worn and burnt.
3. Thrust clearance too large.
i
1. Gears worn of rubbing.
2. Badly worn splines.
3. Primary gears worn or rubbing.
4. Badly worn bearings.
Noise seems to come from transmission
Adjust.
Replace.
Replace.
Replace.
Clean.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.
Replace.